Marine Hot Water Heaters Distributors Share Amazing Suggestions When Using a Multiple Battery System

Your Marine Hot Water Heaters Suppliers Give Needed Tips When Switching to a Multiple Battery System

Raritan Engineering your marine hot water heaters experts would like to share with you these topics we thought would be of interest to you this month regarding amazing suggestions to keep in mind when using a multiple battery system. 

Your marine hot water heaters professionals talk about how a multiple-battery system’s best attribute may be the ability to provide engine starting should one battery short out, experience a wiring failure or simply get drained. 

Battery Type

The charging characteristics vary between battery types: absorbed glass mat (AGM), flooded cell and gel cell. Integration with engines, chargers and other components is easier if all batteries are the same type.

Battery Class

For most boaters, a pair of dual-purpose batteries serves as a good foundation. A ­starting battery and a deep-cycle battery, or bank of batteries, might serve a bass fisherman, or other boater with high accessory demands, better.

Battery Capacity

Ensure sufficient starting amperage by checking your engine’s owner’s manual for the appropriate capacity. Selecting the deep-cycle battery’s — or bank’s — size is more ­involved. 

Manual Switching

Manual switches are reliable but require you to remember to manually switch between batteries (or banks) in order to keep all batteries charged.

Automatic Switching

Voltage sensitive relays (VSR), and other devices, sense when a battery needs a charge and direct charging current from the alternator ­automatically. These can be built into the engine or may be a separate component. 

Your Marine Hot Water Heaters Manufacturers Continue Discussing How to Install a Multiple Battery System

Check out our marine water heaters selection here at Raritan Engineering, where we always take care of your marine sanitation supply needs.

Cables

Cable diameter is directly related to a dual-battery system’s performance. There are formulas you can reference for determining the size of cable based on the amperage it must carry and over what distance.

Starting batteries deliver high amperage for quick engine starts but do not tolerate being used to power equipment. Deep-cycle batteries can be drawn down without damage to power equipment but may not provide enough amperage in a burst to start the engine. 

How to Install a Marine Dual-Battery System

If you have a boat with just one battery, it’s wise to add another, giving you twice as much battery capacity in case, for instance, you inadvertently drain a battery with the stereo while the engine is off. 

Choose a Switch

Make sure the selector switch is designed for two batteries (some are on/off switches) and will handle the amperage when starting the engine. A rating of 250 amps continuous is sufficient for most outboards and gasoline inboards. 

2. Install the Second Battery

Choose a marine battery that meets the engine specs. Installation should comply with Coast Guard and ABYC standards. Wet-cell batteries should be secured in a battery box. 

3. Pick a Location for the Switch

Selector switches have a four- to-six-inch-wide footprint, so pick a surface where you have enough space. ABYC standards dictate that the switch be as close to the batteries as possible and readily accessible. 

4. Connect the Positive Cables

Cables should have “marine cable” stamped on the insulation. Size 2/0 cable handles most outboards and gasoline inboards. Connect the positive terminals of batteries 1 and 2 to the corresponding posts on the back of the switch, and then connect the positive cable from the engine to the output post of the switch. 

5. Connect the Negative Crossover

In order for the dual-battery system to operate properly, you need a crossover cable between the negative terminals of the two batteries. 

Woman caught in Williamson Co. hiding 41 lbs. of meth in boat batteries

WILLIAMSON COUNTY, Texas (KXAN) — Deputies arrested a woman during a traffic stop they say had 41 pounds of meth hidden inside batteries made for boats or jet skis.

Verdiguel told them she was on her way from Laredo to Dallas for real estate classes, but they became suspicious of her after she acted nervously.

After giving them permission to search her car, deputies found the batteries full of meth inside a toolbox in the back of her pickup.

Officers pulled her over near I-35 and 51st Street last Wednesday and found the drugs hidden in three jugs of degreaser. APD says Ayala faces federal drug trafficking charges.

So don't forget these helpful tips when using a multiple battery system. 1) The charging characteristics vary between battery types;  2) for most boaters, a pair of dual-purpose batteries serves as a good foundation;  and 3) ensure sufficient starting amperage by checking your engine’s owner’s manual for the appropriate capacity.

Order your marine water heater here at Raritan Engineering. We are your #1 expert in marine sanitation supplies.

via Multiple-Battery System Tips

via How to Install a Marine Dual-Battery System

via Woman caught in Williamson Co. hiding 41 lbs. of meth in boat batteries